Revo Stage 1 for Audi, A6 (C5 1997 – 2004), 1.8 Turbo – VVT K03 (150ps)

Technical Data

Stage 1 software details for your AUDI, A6 (C5 1997 – 2004), 1.8 Turbo – VVT K03 (150ps)
The 1.8T engine has huge tuning potential even in standard form. Revo Stage1 software gives great increases in power and torque throughout the rev range making any vehicle with the 1.8T engine much more capable and fun to drive. Revo stage1 software is designed to maximise the potential of the engine whilst working safely within standard hardware limitations, our software is tuned for drivability giving you the most useable power/torque throughout the rev-range. Rather than chasing peak dyno figures we tune to give you fantastic power delivery and a spread of torque throughout the rev range. This software will be setup by your Revo Dealer to suit the fuel quality and conditions your car is being used in. Along with the performance benefits from Stage1 software most drivers also see improvements in fuel economy.
SPS Settings
Stock Mode – (Position 1 on your SPS)
Puts the car into a ‘stock’ running mode. When running in Stock mode Revo software is still present and installed on your ECU just not active.
Performance Modes (Positions 2, 3, and 4 on your SPS)
The three Performance Modes are Boost and Timing adjustable, your Revo Dealer can set these modes up to suit your requirements. Settings can be setup to suit fuel quality differences, atmospheric condition differences (hot/cold weather), and driver preference (Low Boost/High Boost) or can be set to a Valet Mode which limits RPM to 3500 and doesn’t allow the engine to make any boost.
Anti-Theft ON – (Position 5 on your SPS)
When Anti-Theft is active the vehicle cannot be driven even if the keys are used. When the ignition is turned on the car will start and idle but will not respond to throttle input.
Anti-Theft OFF – (Position 6 on your SPS)
Turns off Anti-Theft Mode. Reverting to the last used mode (stock or performance 1,2,3)

Power (bhp)Torque (lbft)

Stock
150ps
160lbft

REVO Stage 1 Software
from 190ps to 200ps
from 205lbft to 225lbft

Please Note that this is a Workshop only conversion – we are located in South East of England 30 minutes form junction 30 on M25 (post code SS8 0RA)